respironics encore pro for windows vista

More and more moisture builds up reducing the insulating property of the window and will eventually damage the glass. Once fogging occurs the damage will only get worse. How long the process takes is dependent upon the quality of the silica dessicant used within the spacer bar. Eventually ALL thermal windows will fail. Windows are actually designed with a certain lifespan in mind, since you don’t want exploding windows. Now there is nowhere else for the moisture to go, so it starts building up on the glass inside the void creating the foggy effect Over a period of years this cycle of solar pumping will mean that eventually the silica dessicant will have absorbed all the moisture it can since it has become fullly saturated. This air naturally contains tiny amounts of moisture which is absorbed by the silica dessicant in the window cavity. In the evening the window begins to cool and this causes low pressure within the window which results in the opposite effect. Tiny amounts of air are forced out through the semi-permanent seal. Your windows are not fully hermetically sealed if they were they would explode when the sun heats them up!ĭuring the day, sunlight heats the space in between the two (or three) panes of glass in your window which causes pressure to build up in the void. Our foggy window repair service can give your windows a new lease of life and extend their lifespan by up to twenty years.įoggy windows are caused by a phenomenon known as solar pumping. These machines did not gather waveform data, nor Central events, so the reports are unchanged.If you have foggy windows it doesn’t necessarily mean that you have to rip them out and replace them. I get the same reports I had with EncoreViewer 1.0 and Pro 1.8. If you want to try Pro, send me an email or if you have questions about what I have said here. Later when you obtained the PR S1 machine then use that software with it to get the waveform data. Encore Pro 2.xxx is needed for waveform data but until you upgrade to PR S1 machine.Īre you planning on getting the new PR S1 machine anytime soon? Then you could go ahead and use Encore Pro 2.xx now if you had the card reader for the older machines. You would do just as well with EncoreViewer 1.0 or 2.0. You will need the DT3500 to use either EncoreViewer or Encore Pro.īUT neither of those older machines will gather waveform data so even if you got EncorePro 2.xxxx it will not show waveform for any machine except the newer PR System One series of machines. Special card reader is needed for the older Remstar Auto and also for the not quite so old M series Auto.

Is it worth the effort to go 'pro?' How hard and expensive is it to get 'pro' vs. However, pro is harder to get and more expensive. The Encore Viewer Pro would give me the additional ability to view waveforms. I think what I need is Encore Viewer 2.0 plus a card reader.

Archangle wrote:I've got a Remstar Auto M series with CFLEX.

Respironics encore pro for windows vista